|
|
|
公司基本資料信息
|
||||||||||||||||||||||
| 規格 Specification |
額定電壓 Rated voltage |
非電感性負載 Nonelectrical carry |
電感性負載(A) Electrical carry |
||||||
| 電阻性負載 Resistance oarry |
燈泡負載 Bulb carry |
電感性負載 Electrical carry |
馬達負載 Motor carry |
||||||
| NC | NO | NC | NO | NC | NO | NC | NO | ||
| 21A | AC 250 | 21 | 3 | 12 | 7 | ||||
| DC 8 30 125 250 |
21 14 0.6 0.3 |
5 5 0.1 0.05 |
12 12 0.6 0.3 |
7 5 0.1 0.05 |
|||||
| 16A | AC 250 | 16 | 2 | 10 | 3 | ||||
| DC 8 30 125 250 |
16 10 0.6 0.3 |
4 4 0.1 0.05 |
10 10 0.6 0.3 |
6 4 0.1 0.05 |
|||||
| 15A | AC 250 | 15 | 2 | 10 | 3 | ||||
| DC 8 30 125 250 |
15 10 0.6 0.3 |
4 4 0.1 0.05 |
10 10 0.6 0.3 |
6 4 0.1 0.05 |
|||||
| 11A | AC 250 | 11 | 1.5 | 6 | 2 | ||||
| DC 8 30 125 250 |
11 6 0.6 0.3 |
3 3 0.1 0.05 |
6 6 0.6 0.3 |
3 3 0.1 0.05 |
|||||
| 10A | AC 250 | 10 | 1.5 | 6 | 2 | ||||
| DC 8 30 125 250 |
10 6 0.6 0.3 |
3 3 30.1 0.05 |
6 6 0.6 0.3 |
3 |
|||||
| 操作速度 Operation speed |
0.1mm至1m/S(按鈕型) 0.1mm to 1m/Sec |
| 動作頻率 Action frequency |
機械:600次/分 電氣:60次/分 Mechanically:600 times/minute Electically:60 times/Minute |
| 接點電阻 Contact resistance |
15MΩ以下(初期) Under 15mΩ(initial) |
| 絕緣電阻 Insulation resistance |
100MΩ以上(在500VDC) 100mΩ above (at 500VDC) |
| 耐電壓 Bearing voltage |
非連續端子間1,000VAC,50/60Hz持續1分鐘 載電流與無載電流零件間與端子和接地之間1,500VAC,50/60Hz持續1分鐘 Non-contact end:1,000VAC,50/60Hz for one minute Current parts and noncurrent parts and end and connect position :1,500VAC,50/60Hz for one minute |
| 振動 Vibration |
10至55HZ 復振幅誤動作:1.5mm 10 to 55HZ:1.5mm pairs swing action |
| 沖擊 Hitting |
機械耐久：400m/Sec2(約40G,S) 誤動作耐久：100m/Sec2(約10G,S) Machine:400m/Sec2( Action:100m/Sec2( |
| 周圍溫度 Ambient temperature |
-25℃至 +80℃ -25℃ to +80℃ |
| 濕度 Humidity |
85% RH 以下 Below 85% RH |
| 使用壽命 Serve life |
機械:5,000,000次以上(在額定OT值下) 電氣:100,000次以上 Mechanically:5,000,000 times above(at rated ot) Electrically:100,000 times above |
| 重量 Weight |
約6.2g(按鈕型) |
| 注意事項 Matters needing attention |
| 1 開關請注意不要掉落,屬于低負荷量專用開關,恐造成內部機構的破損。 2 附專動軸規格者，安裝時請勿將傳動軸本體重量加在開關的方向。 3 高溫下請勿使用，外殼使用熱可塑性樹脂做成，在高溫下可能會使其變形損壞。 1 Please do not fall when opened or closed,for it belong to low load switch,Feared that causes the Damages of inside. 2 Attaches the Special moving axis,when it is Installed,forbid putting the weight in Special moving axis. 3 Do not use when the temperature is high. |
©2002-2011 無錫市昌林自動化科技有限公司 SYSTEM All Rights Reserved
地址：無錫市會北路28-135號（金山北科技產業園） 電話：0510-82306988 82306988 傳真：0510-82326771蘇ICP備08106544號-1
點擊圖片查看原圖
